i have got a "E" reg dihatsu fortrack rocky.

my engine is the non turbo one so i dont know if it will differ or not

but basicly all i did was, scrap air filter, then take a 90 degree bend from some down pipe from guttering, this slotted into the ruber pipe going to the inlet manifold nicely, a bit a silicone and a jubaly clip and that sealed.

i found it usefull to test every join as i put them on, start engine, and put your hand over your latest join.
if the engine stalls, and your hand is bieng pulled into the inlet manifold then its works

then i cut the hole in the wing, and tek screwed a old cutter bracket onto the bit that holds windscreen in place.

after i have checked this i found some pipe that fitted onto my 90 degree bend, siliconed it and put 3 jubalee clips onto it to hold it secure.

again after it had dried, i tested it and hey presto it stopped!

then got a old tractor mushroom air filter and plonked it ontop and it works beautifuly!

if u would like some pics of how i did it then let me know

henry